LED transparent display screens are increasingly being used in various industries and are favored by major businesses. Various problems are inevitably encountered during daily use.
LED transparent display screen usage environment.
1. The working environment temperature range is -20 ℃ ≤ t ≤ 50 ℃, and the working environment humidity range is 10% to 90% RH;
2. During the use of the display screen, it should be avoided to use or store it in high temperature, high humidity, high acid/alkali/salt environments;
Working effect diagram of LED transparent window screen
3. Keep away from flammable materials, gases, and dust;
4. When the ambient temperature is too high or the heat dissipation conditions are poor, please be careful not to use the LED transparent display screen for a long time; Easy to cause damage to the internal circuit board of the display screen.
5. When the LED transparent display screen with humidity exceeding the specified humidity is powered on, it can cause component corrosion or even short circuit, resulting in permanent damage;
6. It is strictly prohibited to allow water, iron powder, and other easily conductive metal objects to enter the screen. LED transparent display screens should be placed in a low dust environment as much as possible. Excessive dust can affect the display effect and make it easier to damage the circuit. If water enters due to various reasons, please immediately turn off the power and dry all components before use.
Working effect diagram of LED transparent display screen
Switching sequence of LED transparent display screen
1. When turning on the screen, pay attention to the order of the switches: turn on the screen first, fully light up and preheat the screen, and then turn on the screen. When turning off the screen, the order is reversed: first turn off the screen, then turn it off. If the computer is turned off first, it will create a high brightness on the screen, and the light tubes are prone to burning out, affecting the lifespan of the screen and causing serious consequences.
2. The time for each startup and shutdown should be greater than 5 minutes. Frequent startup and shutdown can cause a short lifespan and short circuit of the display screen.
3. The screen power can only be turned on after the computer enters the engineering control software.
4. Avoid opening the screen in a fully white state, as the system’s surge current is at its maximum.
Working effect diagram of LED transparent display screen
5. When the ambient temperature is too high or the heat dissipation conditions are poor, LED lighting should be careful not to turn on the screen for a long time.
6. If there is a very bright line on a certain part of the electronic display screen, the screen should be turned off in a timely manner. In this state, it is recommended not to open the screen for a long time.
7. The power switch of the display screen frequently trips, so it is important to check the screen or replace the power switch in a timely manner.
8. Regularly check the firmness of the hooks. If there is any looseness, please make timely adjustments, re reinforce or update the suspension components.
9. According to the environmental conditions of the display screen and control components, insect bites should be avoided, and rodent repellent should be placed if necessary.